Gemini Industries CDX-1200 User Manual download pdf (Page 4)

CDX-1200

FUNCTIONS: (CONTINUED)

SINGLE: Pressing the SINGLE button engages SINGLE mode, in this

mode the CDX-1200 will play one song and then stop. Pressing the

SINGLE button again will then activate CONTINUOUS mode causing

the unit to play continuously (after the last track, the unit will return to

the first track of the disc and continue to play).

TIME: The TIME BUTTON switches the time display between three

available sources, these three are TIME ELAPSED on the track, TIME

REMAINING on the disc and and TIME REMAINING on the track.

TIME ELAPSED indicates how much time has currently gone by since the

play button was pressed, TIME REMAING ON DISC will count down the

time remaining on the entire disc and TIME REMAINING ON TRACK

counts down the time that is left before the end of the track.

PITCH: Pushing the PITCH button (the button will light up blue) activates

the PITCH CONTROL SLIDE. The pitch or speed of the CD will change

plus or minus 12% depending on the position of the PITCH CONTROL

SLIDER. Push the PITCH button again to deactivate this mode.

PITCH CONTROL SLIDE: Moving the PITCH CONTROL SLIDE

up or down will lower or raise the pitch percentage + or - 12%.

PITCH BEND: Pushing the PITCH BEND BUTTONS will automatically

raise the pitch up to +16% or lower the pitch down to -16% from the

existing pitch setting. Releasing the buttons will return the pitch

to the original pitch setting. You can use this function to match the beat

when mixing from one song to another

LOOP SECTION: A LOOP repeats the section between the entry point

(IN) and the exit point (OUT). To set a loop while the unit is playing,

start by pressing the IN BUTTON (it will light up) and when you reach

the desired end loop point press the OUT BUTTON (it will also light up).

The loop will continue playing until you press the OUT BUTTON again

allowing the music to continue from that point on, to re-engage the loop

you must press the RELOOP BUTTON. When you have released your

loop the OUT BUTTON will turn OFF and the IN BUTTON will remain lit

to indicate that your loop is stored in the CDX-1200 memory. Pressing

the IN BUTTON again while the unit is playing will erase the previously

saved loop while saving your new loop entry point. Press OUT to exit the

loop and save a new complete loop.

Press RELOOP to return to the beginning of the previously saved loop

from normal play. Press RELOOP repeatedly to cause the loop to stutter.

NOTE: THE FIRST LOOP WILL HAVE A PAUSE AT THE EXIT POINT,

WHILE ALL OTHERS WILL BE SEAMLESS.

PLAY/PAUSE: Each press of the PLAY/PAUSE BUTTON

causes the operation to change from PLAY to PAUSE or from PAUSE

back to PLAY. The PLAY/PAUSE BUTTON remains lit when in PLAY

mode, while it blinks in PAUSE mode.

CUE: While the unit is playing and after the cue point has been

programmed, pressing CUE will cause the CD player to enter the

PAUSE mode (PLAY/PAUSE BUTTON blinks) at the programmed cue

point (the CUE LED is lit). Holding down the CUE button

changes the function to preview , and allows you to stutter start or play

from the programmed CUE POINT Releasing the CUE button will return

the CD to the preset CUE point.

STOP BUTTON: When pressed the STOP BUTTON stops the playback

of the CD player.

TRACK SELECTION: The TRACK SELECTION buttons let you select

the track to play. +10 allows you to scan through the track selection

in increments of 10. TRACK SKIP allows you to scan through each

track one at a time.

OTE : ONCE YOU HAVE SKIPPED TO ANOTHER TRACK, YOU MAY NOT GO BACK

O YOUR PROGRAMMED CUE POINT. YOU MUST BEGIN YOUR CUE SELECTION

OVER AGAIN, THE CUE WILL BE PRESET TO THE BEGINNING OF THE NEWLEY SE-

LECTED TRACK.

TROUBLESHOOTING:

- If a disc will not play, check to see if the disc was loaded correctly

(label side up). Also check the disc for excessive dirt, scratches, etc.

- If the disc turns but there is no sound, check the cable connections,

if they are ok, check your amplifier or reciever.

-If the CD skips, check the CD for dirt or scratches. Do not assume that

the CD player is defective. Many cd’s are recorded out of spec and

will skip on most or all CD players. Before sending the unit for repair,

try playing a CD that you are sure plays properly.

SPECIFICATIONS:

GENERAL:

Type................................................................................Compact Disc Player

Disc Type...................................Standard Compact discs (12 cm & 8 cm)

Time Display......................Track Elapsed, Track Remain, or Total remain

Variable Pitch.......................................± 12% Slider with Resume Switch

Pitch Bend............................................................................± 16% Maximum

Instant Start....................................................................Within 0.03 seconds

Installation...........................................................................................19" each

Dimensions.........Main unit: 19" x 3.5" x 10" (482.6 x 88.9 x 254 mm)

Weight Per Unit..........................................Main unit: 11.35 lbs. (5.14 kg)

AUDIO SECTION:

Quantization......................................1 Bit Linear/Channel, 3 Beam Laser

Oversampling Rate..............................................................................8 Times

Sampling Frequency..........................................................................44.1 kHz

Frequency Response............................................................20 Hz to 20 kHz

Total Harmonic Distortion...................................................Less Than 0.05%

Signal to Noise Ratio..............................................................................85 dB

Dynamic Range........................................................................................85 dB

Channel Separation.................................................................85 dB (1 KHz)

Output Level...................................................................2.0 +/- 0.2V R.M.S.

Power Supply.......................................................AC 115/230V, 60/50 Hz

SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE WITH-

OUT NOTICE FOR PURPOSE OF IMPROVEMENT.

1 2 3 4

CDX-1200 1

Comments to this Manuals

No comments

Gemini Industries CDX-1200 User Manual Page 4

Comments to this Manuals

Related products and manuals for CD players Gemini Industries CDX-1200